Cleaning and care
54
Pre-rinse
If the steam ironing system is still hot
from the previous use, the cool down
phase will start first. This may take up
to 3hours.
The pre-rinse phase then follows (dura-
tion approx. 20minutes). During this
time, a portion of the descaling solution
is pumped into the steam generator.
After the pre-rinse phase you will be
prompted to carry out further actions.
This will be shown for a few seconds
before the pre-rinse phase starts and
will be indicated by the message In
20 min. .
Rinse water container and fill to
the mark
Remove the water container from the
tower.
As long as the water container is not in-
serted into the tower, the display will
show the following message Fit water
container.
Open the screw cap.
Rinse the water container thoroughly.
Make sure no residues of the descal-
ing tablets remain in the water con-
tainer.
Fill the water container with fresh wa-
ter at least up to the level marking.
Close the screw cap.
Put the water container back into the
tower.
To Next Page
Loading...
Need help?
General
