Ironing
35
The continuous emission of steam
must have stopped before the iron is
put back on the resting surface!
If the steam button was not unlocked
before placing the iron down, steam
will stop being produced after ap-
prox. 3minutes and Release stm.
button will appear in the display.
When turning off the iron, unlock the
button by pushing the slider
forwards.
Filling the water container
Fill the water container when the
message Fill water cont. appears in
the display (see “Filling the water
container”).
When using the steam function for a
long time during ironing, condensa-
tion can build up in the ironing board.
Sensitive floors can be damaged by
droplets of water.
If you notice condensate underneath
the ironing board, use a cloth to wipe
it off.
Tip: If you take a break from ironing,
condensate may collect in the steam
hose. Press the button to expel the
condensate from the hose. To prevent
the garments from becoming damp, do
not direct the first burst of steam onto
the garment after a break in ironing.
Ironing without steam
Remove the water container from the
steam ironing system if you want to
iron without steam.
The steam generator will not heat up
and saves you energy.
Ironing with the non-stick sole-
plate
With the non-stick soleplate you can
iron appliqués, prints, flocking etc.
There is no need to turn the garment in-
side out. This soleplate also reduces or
eliminates the formation of shiny
patches on dark textiles.
Always try it first on an inconspicuous
part of the fabric.
The iron soleplate gets very hot
during use!
Avoid direct contact.
To Next Page
Loading...
Need help?
General
