Miele PIB 100 User Manual

Ironing
37
Active ironing board
The steam ironing system uses a fan
that sucks away the steam or uses the
inflation function to inflate the ironing
board for optimum positioning while
ironing garments.
The ,  or ,  buttons on the
iron control the fan in the ironing board.
Suction function
The suction function ensures optimum
steam penetration of the fabric. At the
same time, the suction avoids the form-
ation of condensation on the ironing
board. The suction function also holds
the garment in place and ensures it
does not shift on the ironing board.
Inflation function
The inflation function forms a cushion of
air between the fabric and the ironing
board. This helps prevent seams being
pressed into the garment. The inflation
function allows you to iron without flat-
tening the fabric.
Tip: The inflation function also assists
with ironing ruffles and sequins.
Automatic switch on/off
The automatic switch on/off feature en-
sures that the fan starts at exactly the
right moment. If the steam function is
being used, the fan starts automatically.
If steam is no longer needed, the fan
will stop after a short run-on time.
Memory function
The memory function saves the fan dir-
ection and the power setting used last
with your steam ironing system. When
you use the appliance the next time,
you do not need to set it again.
Heated ironing surface
When the iron is connected and the
steam ironing system is switched on,
the surface of the ironing board will
heat up automatically. This function re-
duces the formation of condensation on
the ironing board.
If the steamer is connected to the
steam ironing system, the surface of
the ironing board will not be heated.
Fan control for the PIB 100
Activating the inflation and suction
function
Press the button to switch between
the inflation function and the suction
function. Use the button to activate the
function.

Miele PIB 100 Specifications

General

Brand	Miele
Model	PIB 100
Category	Iron
Language	English