Contrast / Brightness
Display contrast and brightness can
be changed in 10 levels.
The bar shows the selected level.
Standby
The display goes out after 10
minutes and the "Start" button
flashes slowly to save energy.
on
Standby is turned on:
– when no program was selected.
– after pressing the "Start" button.
– at the end of a program.
not during current program
(factory default)
The Standby is turned on:
–
when no program was selected.
Pressing any button turns the display
on again.
Buzzer
When the buzzer is selected a tone
sounds at the end of a program.
Off
The end-of-program buzzer is turned
off.
However, it does not turn off the
warning tone indicating a fault
message.
normal
The buzzer sounds at the end of a
program "normal" (factory default).
loud
The buzzer sounds at the end of a
program "loud".
Lengthening the cooling time
The cooling phase can be
lengthened before the program is
started. The laundry will be cooler.
The bar shows the selected level.
Delivery status: 0 minutes (normal
cooling down phase).
–
The program duration is extended
respectively.
The cooling time cannot be extended in
the programs "Warm air, Cool air,
Woollen handcare and Smoothing".
Settings J
51
To Next Page
Loading...
