Other faults
What if ... Possible fault Solution
The program
runs too long or
stops.
In some cases "Clean out airways" is displayed. See "Clean
out airways". Open and close the dryer door.
The air supply is
insufficient.
Open a window or door to
increase air flow.
The lint filter is clogged
with lint.
Remove the lint.
The exhaust hose or the
connection is clogged with
lint.
–
Check regularly on the
exhaust parts (e.g. wall vent
duct, louvered wall vent,
bends, etc.) for air
permeability.
– Remove the lint.
The laundry was not spun
sufficiently in the washer.
Spin laundry thoroughly before
drying.
The dryer is over-loaded. Regard the maximum load size
per program.
Metallic zippers prevent a
correct measurement of
the laundry’s residual
moistness.
– Open the zippers of the
laundry before drying.
If the problem persists, dry the
items with long zippers only in
the "Warm air" program.
The laundry is
not dry enough.
The load contained too
many dissimilar items (size
and fabrics.)
–
Continue drying on the "Warm
air" program.
–
See the "Program Guide" for
suitable programs.
Frequently asked questions
23
To Next Page
Loading...
