Cleaning
Tip: You can also use a vacuum
cleaner to remove the fluff. This makes
it easier to clean the filter with water.
^
Clean the filter thoroughly under
running water.
,
Then squeeze the filter
thoroughly. It must not be replaced
dripping wet as this could cause a
fault in the dryer.
^
Use a damp cloth to remove any fluff
from the handle.
Cleaning the access panel and the
heat exchanger housing
^
Use a damp cloth to remove any fluff.
Make sure that you do not damage
the rubber seal when doing this.
^
Check whether there is any fluff in the
area in front of or on the cooling fins.
,
Danger of injury.
Do not touch the cooling fins. You
could cut yourself.
,
Prevent damage.
Carefully pass the vacuum cleaner
brush over the surface, without
applying any pressure.
Otherwise the cooling fins or the
struts and guide pins in front of them
could become damaged.
Visible soiling:
^
Remove any soiling carefully with the
vacuum cleaner and dusting brush:
–
from the area in front of the cooling
fins.
–
from the cooling fins.
Cleaning and care
37
To Next Page
Loading...
