Replacing
^
Fit the filter back on the handle. Make
sure it is the correct way round.
To ensure that the filter is positioned
correctly in the front of the heat
exchanger unit:
^
First insert the handle with the filter
attached over the two guide pins.
Make sure that the yellow dot on
the handle is on the right.
^
Push the filter in completely.
A programme cannot be started if
the filter is not replaced in the dryer
or is replaced the wrong way round.
A message will appear in the
display.
^
Close the access flap.
,
The filter must be fitted correctly
and the access flap closed to
ensure that water cannot leak from
the condenser system and to ensure
that the dryer functions efficiently.
Cleaning and care
38
To Next Page
Loading...
