Example: Connection to a sink drain
outlet
1 Adapter*
2 Nut
3 Hose clip*
4 Extension hose*
5 Non-return valve and hose clip*
6 Tumble dryer drain hose
* Accessory
^
Fit adapter 1 to the sink drain outlet
using nut 2.
If this nut has a flat disc in it you
should take the disc out first.
^
Attach the end of the hose 4 to
adapter 1.
^
Use a screwdriver to tighten hose
clip 3 up close to the nut.
,
Non-return valve 5 has to be
fitted with the arrow pointing in the
direction of flow (i.e. towards the
sink). Otherwise water will not drain
out of the tumble dryer.
^
Fit non-return valve 5 to the tumble
dryer drain hose 6 (make sure it is
fitted in the correct direction (see
arrow on non-return valve).
^
Secure the non-return valve using
hose clips.
Installation and connection
56
To Next Page
Loading...
