Electrical connection
,
All electrical work must be
carried out by a suitably qualified
and competent person in
accordance with current local and
national safety regulations (BS 7671
in the UK).
This machine is supplied with a
connection cable and moulded plug
(BS 1363) for connection to a 230 V
mains supply.
The machine must only be operated
with the voltage, frequency and fuse
rating shown on the data plate supplied
with the machine. Please ensure these
match the site mains supply.
We recommend connecting the
machine to the power supply via a
suitable plug and socket which must be
easily accessible for servicing and
maintenance work after the machine
has been installed.
Do not connect the machine via an
extension lead. Extension leads do not
guarantee the required safety of the
machine (e.g. danger of overheating).
For extra safety and protection we
recommend connecting the machine by
a 30 mA residual current device (RCD).
An electrical safety test must be carried
out after installation and after any ser
-
vice work.
The mains connection cable may only
be replaced by an original Miele spare
part.
,
If the machine is disconnected
from the electricity supply adequate
measures must be taken to ensure
that the machine cannot be
reconnected to the electricity supply
until all work has been carried out.
,
The machine must be
permanently connected to the
electricity supply to enable the
programme to complete and to
enable the load to cool down after
drying. For this reason it must not be
connected to devices such as timers
which would switch it off
automatically.
WARNING
THIS MACHINE
MUST BE EARTHED
Installation and connection
57
To Next Page
Loading...
Need help?
General
Weight and Dimensions
