Clean out airways
The electronic unit in the dryer
detects the degree of a blockage
caused by fluff or detergent residues
in the filter, and the following prompt
comes up in the display: Clean plinth
filter You can decide at what level of
fluff this message should appear.
You will have an idea of how often this
should be done after a few drying
programmes.
–
Off
The prompt does not appear.
In cases of a very severe blockage in
the ducting, the programme is
cancelled and Clean plinth filter
comes up regardless of this option.
– Heavy
The prompt only appears when there
is a heavy build-up of fluff.
–
Normal
(Factory default)
–
Light
The prompt appears when there is
only a small build-up of fluff.
Delay start
You can set a later start time using
Delay start (see "Delay start").
You can decide how this time is
displayed.
–
Programme end
The finish time for the programme is
selected.
–
Programme start
The start time for the programme is
selected.
– Time until start
The time until the start of the
programme is selected in
minutes/hours.
– Off
(Factory default)
By pressing the + button, the time
remaining and the finish time for the
programme is displayed.
Settings menu
64
To Next Page
Loading...
