Before using for the first time
23
Select pre-wash water
Touch the coldsensor if the washing
machine is only connected to a cold
water supply, or touch hotif the
washing machine is connected to
cold and hot water.
The display will change to the next set-
ting.
Select main wash water
Touch the coldsensor if the washing
machine is only connected to a cold
water supply, or touch hotif the
washing machine is connected to
cold and hot water.
Further information will appear on the
display.
Removing the transit bars
The display will remind you to remove
the transit bars.
Damage resulting from failure to
remove the transit bars.
Failure to remove the transit bars can
result in damage to the washing ma-
chine and to adjacent furniture or ap-
pliances.
Remove the transit bars as described
in “Installation and connection”.
Confirm that the transit bars have
been removed with the OKsensor.
Continue setting up as described in the Op-
erating Instructionsappears in the dis-
play.
Confirm the message with the
OKsensor.
To Next Page
Loading...
Need help?
General
