6. End of programme - unload the drum
35
End of programme
The programme is finished when Finish/
Anti-crease appears in the display. The
Start/Stop sensor will no longer light up.
The dryer will switch off automatically
15minutes after the end of the Anti-
crease phase (with programmes without
an Anti-crease phase it will switch off
15minutes after the end of the pro-
gramme).
Unloading the drum
Only open the door when the drying
process has finished. Otherwise, the
laundry will not be properly dried
through and cooled down.
Pull the door open at the side with
the orange marker.
Remove the laundry.
Items left in the dryer could be dam-
aged by overdrying when the dryer is
used the next time.
Always remove all items from the
drum.
Touch the sensor to switch the
tumble dryer off.
Remove the fluff from the 2 fluff filters
in the door opening: see “Cleaning
and care – Fluff filters”.
Shut the door with a gentle swing.
Empty the condensed water con-
tainer.
Tip: The condensed water can be used
for the Steam care programme. See
“Cleaning and care - Preparing the con-
densed water container for the Steam
care programme”.
We recommend that you drain the con-
densed water externally through the
drain hose when drying a full load using
the Cottons and Cottons pro-
grammes. This will avoid having to
empty the condensed water container
during the programme.
Drum lighting
The inside of the drum lights up so that
you don't forget any items of laundry
when you empty it.
The drum lighting switches off automat-
ically (energy saving).
Tip: To switch the lighting on again,
open the pull-down menu from the
overview menu and then touch the
sensor.
To Next Page
Loading...
Need help?
General
