Problem solving guide
67
General problems with the tumble dryer
Problem Cause and remedy
You can hear operating
noises (buzzing/hum-
ming).
This is not a fault.
The compressor (heat pump) is operating or you have
selected the Steam Care programme.
No action required. These noises are quite normal
and can be heard when the compressor or the
condensed water pump is operating.
A programme does not
start
No obvious cause.
Connect the tumble dryer to the mains
Turn on the tumble dryer
Close the door
Check whether the mains fuse has tripped
Has there been a power cut? When power is restored
any previously running programme will restart auto-
matically.
The display is dark and
the Start/Stop control is
flashing slowly.
The display has switched off automatically to save
energy (Standby mode).
The drum will turn at intervals in the anti-crease
phase.
Press any control. This switches Standby off.
The dryer is switched
off at the end of the
programme.
The tumble dryer switches off automatically. This is
not a fault, but a normal function.
See “Settings – Appliance switch-off”.
The display is in a dif-
ferent language.
A different language has been selected in “Settings,
Language ”.
Set the language you want. The flag symbol serves
as a guide.
The interior drum light-
ing does not come on.
Not a fault. The drum lighting switches off automatic-
ally in the following cases:
If the door is closed.
If the door remains open for an extended period of
time.
To Next Page
Loading...
Need help?
General
