Installation and connection
77
Arranging the drain hose
Damage to the drain hose due to
incorrect handling.
If the drain hose is damaged, water
may leak out and cause damage.
Do not pull excessively on the drain
hose and do not stretch it or allow it
to become kinked.
There will be a small amount of residual
water left in the drain hose. Have a con-
tainer ready to collect this.
Version 1
Version 2
Pull the drain hose off its connection.
Unwind the hose and pull it carefully
out of the holders.
Allow any residual water to run into
the container.
Guide the hose to the right or left side
of the dryer, as required.
– If you are guiding it to the right you
can fit the hose into the groove.
– Leave the hose in the lower holder to
prevent it from being kinked by mis-
take.
Examples: Draining of condensed
water
The illustrations show the process of
removing the accessories for the ex-
ternal condensed water connection in
version 1. In version 2, the accessor-
ies for the external condensed water
connection are supplied separately.
– Drainage into a sink or floor gully
Use the hose holder to prevent the
drain hose from becoming kinked.
To Next Page
Loading...
