Cleaning and care
60
Cleaning the plinth filter
Pull the handle out of the plinth filter.
Clean the filter thoroughly under run-
ning water.
Squeeze the water out of the plinth
filter thoroughly.
The plinth filter must not be replaced
dripping wet. This can cause a fault.
Use a damp cloth to remove any fluff
from the handle.
Cleaning the plinth filter panel
Use a damp cloth to remove any fluff.
Make sure that you do not damage
the rubber seal when doing this.
Check whether the cooling fins are
blocked with fluff (as follows).
To Next Page
Loading...
Need help?
General
