Skipping program cycles
Cycles of a program in progress can be
skipped or repeated.
^
Press 7 "End" and the program is
stopped.
PROGRAMME 2 COTTONS
Main wash
PROGRAMME STOP
PROGRAMME STOP flashes in the display.
^
Use the 1 or 2 "Cursor" to skip ahead or
move back to a cycle in the program.
^
At the position required press X "Start" to
continue the program again.
Program cancellation
^
To cancel a program, press 7 "End" twice
in succession.
If the program was cancelled while there
was water in the machine, or during a spin,
the following may appear in the display (ex
-
ample):
PROGRAMME 2 COTTONS
PROGRAMME END
DOOR IS LOCKED
WATER IS IN THE MACHINE
or:
PROGRAMME 2 COTTONS
PROGRAMME END
DOOR IS LOCKED
DRUM IS NOT YET STATIONARY
^ Run the Separate Drain or Separate Spin
program. On completion the door can be
opened.
Rinsing with hot water
Standard programs
1 Cottons 200 °F (95°C) and
2 Cottons 140 °F (60°C)
are programmed to rinse with hot water.
If a hot water supply is available it is an ad
-
vantage to run the final rinse with hot water.
This reduces the residual moisture content of
the laundry after spinning.
If the laundry is dried or ironed immediately
after washing, drying times will be shortened
and ironing easier.
Notes
19
To Next Page
Loading...
Need help?
General