9
On opening the software, you will see a screen as shown below. This
is the page for using the pre-installed model set-ups. For the VBar to
be able to connect to your PC or Laptop, you need to install a driver.
Installing the USB Driver
Connect the VBar main unit with your computer using the USB cable.
Now turn on your transmitter and receiver. Your Windows program
will recognize the new hardware and you will see this window:
After about 5 seconds, the VBar is ready to accept the USB connection
to your computer. On initial connection your PC will prompt you to
install the USB driver. If your PC cannot find the required driver
automatically, please find it your VBar CD. The CD should still be in
the CD drive of your PC.
The VBar icon on your desktop
To Next Page
Loading...
