SAFETY GUIDELINES
06 TECHNICAL DOCUMENTATION
CONDITIONS
Mikrofill Systems Ltd. shall not be liable for any damages caused by non-compliance with this manuals
instructions. Only original parts must be used for service purposes.
GENERAL GUIDELINES
The appliance is not intended for use by persons (including children) with reduced mental, physical or sensory
capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction
concerning the use of the appliance by a person responsible for their safety.
It is a statutory requirement that all gas appliances are installed in accordance with the manufacturers
instructions and all regulations in force. All instructions should be fully read before installing or using the
appliance. All installations should be carried out by competent persons as described in the Gas Safety
(Installation and Use) Regulations i.e. Gas Safe registered and holding current certification.
The manufacturers instructions MUST NOT be taken in any way as overriding statutory obligations.
This boiler has been tested and certified to comply with all necessary European directives, latest building
regulations and efficiency requirements, is CE marked and complies with;
• 2009/142/EC Gas Appliance Directive.
• 2014/35/EU Low Voltage Directive.
• 2014/30/EU Electromagnetic Compatibility Directive.
This boiler should be installed in compliance with;
• Building Regulations.
• Building Regulations (Scotland-Consolidated).
• Building Regulations (Northern Ireland).
• The Health and Safety at Work Act.
• Gas Safety (Installation and Use) Regulations.
• Water Fittings Regulations or Water By-laws in Scotland.
• Local Water Company By-laws
The boiler should not be modified in any way. Any modifications will invalidate the gas approval and
invalidate the warranty.
ATTENTION: HIGH VOLTAGE!
Before opening the boiler casing for maintenance or servicing, the 230 VAC main supply
to the boiler must be disconnected!
To Next Page
Loading...
