Milesight UC300 - Page 26

26
2. Set a IF condition based on the terminal device data or UC300 device status.
Condition
Description
Time
Set the time condition. The device time will be synced once after
joining/registering to network, you can also sync the time manually on “Status”
page.
Digital Input
When UC300 device detects the DI as a specific status.
Is continued for: the DI changed status should last for some time.
Set lockout time: after the lockout time, UC300 will detect if DI status matches
the condition. 0 means this IF condition will only be detected once.