To programme a certain voice to a pad, proceed as follows:
1. Press the [voice — vol/pan/tun] button.
ð
The display indicates the current voice number, the Voice LED on the 3-digit display
lights up.
2. Press the button of the pad you want to programme a certain voice for. Alternatively,
you can directly activate the pad by playing it.
ð
The display shows the number of the currently assigned voice. The indicator LED of
the pad lights up.
3.
Select the desired voice using the [–]/[+] button (see
Ä
Chapter 10.1 ‘ Voice list’
on page 42).
4. Repeat steps 2 to 3 to assign the other pads as desired.
Press the [rim] button in the pad selection field to programme a rim voice to the snare
pad or an edge voice to the crash or ride cymbal.
Assigning a voice
Operation
MPS-400
27
To Next Page
Loading...
