Miller Fusion 185 User Manual

OM-284208 Page 21
F
Complete Parts List is available at www.MillerWelds.com
SECTION 5 – INSTALLATION FOR ENGINE POWER
5-1. Installing Welder/Generator
Movement
OM-279105 Page 1
1 Lifting Handles
Use handles to lift unit.
2 Hand Cart
Use cart or similar device to move
unit.
! Do not install unit where air
flow is restricted or engine
may overheat.
! Do not move or operate unit
where it could tip.
! Always securely fasten
welder/generator onto
transport vehicle or trailer
and comply with all DOT and
other applicable codes

Go to MillerWelds.com for
more information on truck
installations.
1-1. Installing Welder/Generator
Rotinstall5-2017-04
18 in.
(460 mm)
18 in.
(460 mm)
18 in.
(460 mm)
18 in.
(460 mm)
18 in.
(460 mm)
1
2
1
Location And Airflow
OM-279105 Page 1
1 Lifting Handles
Use handles to lift unit.
2 Hand Cart
Use cart or similar device to move
unit.
! Do not install unit where air
flow is restricted or engine
may overheat.
! Do not move or operate unit
where it could tip.
! Always securely fasten
welder/generator onto
transport vehicle or trailer
and comply with all DOT and
other applicable codes

Go to MillerWelds.com for
more information on truck
installations.
1-1. Installing Welder/Generator
Rotinstall5-2017-04
18 in.
(460 mm)
18 in.
(460 mm)
18 in.
(460 mm)
18 in.
(460 mm)
18 in.
(460 mm)
1
2
1
1 Lifting Handles
Use handles to lift unit.
2 Hand Cart
Use cart or similar device to move unit.
Do not install unit where air flow is
restricted or engine may overheat.
Do not move or operate unit where
it could tip.
Always securely fasten welder/
generator onto transport vehicle or
trailer and comply with all DOT and
other applicable codes.
F
Go to MillerWelds. com for more infor-
mation on truck installations.

Miller Fusion 185 Specifications

General

Brand	Miller
Model	Fusion 185
Category	Portable Generator
Language	English