Miller S-74 MPa Plus Technical Manual

TM-273245 Page 8
S-74 MPa Plus
SECTION 4 − INSTALLATION
loc_feeder/running gear 2015-05
! Do not put feeder where
welding wire hits cylinder.
. Wire feeder shown is repre-
sentative only and may not
reflect actual unit.
1 Wire Feeder
2 Wire Spool/Reels
3 Gas Cylinder w/Hose And
Regulator (Customer Supplied)
. Shielding gas pressure not to
exceed 100 psi (689 kPa).
4 Welding Power Source
5 Running Gear
6 Water Cooling System
4-1. Selecting A Location
1
3
2
5
4
6
! Do not move or operate unit where it could tip.

Miller S-74 MPa Plus Specifications

General

Brand	Miller
Model	S-74 MPa Plus
Category	Wire Feeders
Language	English