Milltronics SL12 Series User Manual

CHAPTER 6 - MAINTENANCE
Hydraulic Tailstock and chuck pressure adjustments
Adjust pressure to suit requirements of the operation
Pressure adjustments
Hydraulic Chuck Pressure and Proximity Switches
The hydraulic pressure switches are
located behind the left hinged side panel of
the machine.
Each pressure switch is factory set to trip
at 100 psi. The machine will e-stop if
chuck pressure drops below 100 psi.
Adjust as necessary for the application.
39

Milltronics SL12 Series Specifications

General

Brand	Milltronics
Model	SL12 Series
Category	Lathe
Language	English