33
Chapter 6 – Maintenance
Periodic Maintenance; Verification Of Safety Systems
Note: Before performing any of the procedures in this section, please read and follow
the directions in this manual covering safe practices for operation, setting and
maintenance. Maintenance operations should only be performed by qualified personnel
as described in chapter 1.
• Maintenance labels as outlined on pages 9 & 10 are affixed to the machine near
areas where maintenance is required. Become familiar with the various notices
affixed to the machine and there meaning.
• Keep a maintenance log to record all maintenance activity on each machine.
WARNING:
Due to the hazard of live power, special caution should be taken with electrical repairs
or electrical component replacement. Electrical maintenance should only be performed
by qualified personnel as described in Chapter 1. Electrical Safety Rules should be
observed.
Maintenance Schedule
Always
• Remove chips as necessary from the chip pan area.
Daily
• Ensure the air lubrication unit dispenses oil, and that the oil reservoir remains
filled. (Use Marvel No. 085, Mobil Velocite No. 10 or equivalent oil)
• Ensure the water trap (if equipped) is being drained as required.
• Ensure the waylube reservoir level is maintained. (Use Mobil Vactra No. 02,
Amoco Waytec No 68, Sunoco Sunwaylube No1180, or equivalent oil)
• Ensure that all guards are in place and functioning properly.
To Next Page
Loading...
Need help?
General
