8
Pellerin Milnor Corporation
WARNING:
Explosion Hazards — Clutch and speed switch (multiple motor ma-
chines)—A damaged clutch or speed switch can permit the low speed mo-
tor to engage during extract. This will over-speed the motor and pulleys
and can cause them to rip apart, discharging metal fragments at high speed.
� Stop the machine immediately if any of these conditions occur: • ab-
normal whining sound during extract • skidding sound as extract ends •
clutches remain engaged or re-engage during extract
2.1.3.2 Careless Use Hazards
BNWRUS04.C05 0000234651 A.5 B.3 A.2 1/2/20 2:19 PM Released
2.1.3.2.1 Careless Operation Hazards—Vital Information for Operator Personnel
(see also operator hazards throughout manual)
BNWRUS04.C06 0000234650 A.5 B.3 A.3 1/2/20 2:19 PM Released
WARNING: Multiple Hazards — Careless operator actions can kill or injure person-
nel, damage or destroy the machine, damage property, and/or void the
warranty.
� Do not tamper with or disable any safety device or operate the machine with a mal-
functioning safety device. Request authorized service.
� Do not operate a damaged or malfunctioning machine. Request authorized service.
� Do not attempt unauthorized servicing, repairs, or modification.
� Do not use the machine in any manner contrary to the factory instructions.
� Use the machine only for its customary and intended purpose.
� Understand the consequences of operating manually.
2.1.3.2.2 Careless Servicing Hazards—Vital Information for Service Personnel (see
also service hazards throughout manuals)
BNWRUS04.C07 0000234649 A.5 B.3 A.3 1/2/20 2:19 PM Released
WARNING: Electrocution and Electrical Burn Hazards — Contact with electric
power can kill or seriously injure you. Electric power is present inside the
cabinetry unless the main machine power disconnect is off.
� Do not service the machine unless qualified and authorized. You must
clearly understand the hazards and how to avoid them.
� Abide by the current OSHA lockout/tagout standard when lockout/tag-
out is called for in the service instructions. Outside the USA, abide by the OSHA standard
in the absence of any other overriding standard.
WARNING: Entangle and Crush Hazards — Contact with moving components nor-
mally isolated by guards, covers, and panels, can entangle and crush your
limbs. These components move automatically.
� Do not service the machine unless qualified and authorized. You must
clearly understand the hazards and how to avoid them.
� Abide by the current OSHA lockout/tagout standard when lockout/tag-
out is called for in the service instructions. Outside the USA, abide by the OSHA standard
in the absence of any other overriding standard.
Safety
To Next Page
Loading...
