Pellerin Milnor Corporation 7
Table 1 Trademarks (cont'd.)
E-P Plus
®
Mildata
®
MilVision™ Staph Guard
®
Gear Guardian
®
Milnor
®
PBW™
BNWRUS08 / 2019335
BNWRUS08 0000249979 B.3 1/2/20, 2:19 PM Released
Safety — Rigid Washer Extractors
BNWRUS08.C01 0000249978 C.4 B.3 A.3 1/2/20, 2:19 PM Released
Safety Alert Messages—Internal Electrical and Mechanical
Hazards
BNWRUS01.C03 0000234538 C.4 B.3 A.6 1/2/20, 2:19 PM Released
The following are instructions about hazards inside the machine and in electrical enclosures.
WARNING: Electrocution and Electrical Burn Hazards — Contact with electric
power can kill or seriously injure you. Electric power is present inside the
cabinetry unless the main machine power disconnect is off.
� Do not unlock or open electric box doors.
� Do not remove guards, covers, or panels.
� Do not reach into the machine housing or frame.
� Keep yourself and others off of machine.
� Know the location of the main machine disconnect and use it in an emergency to re-
move all electric power from the machine.
WARNING: Entangle and Crush Hazards — Contact with moving components nor-
mally isolated by guards, covers, and panels, can entangle and crush your
limbs. These components move automatically.
� Do not remove guards, covers, or panels.
� Do not reach into the machine housing or frame.
� Keep yourself and others off of machine.
� Know the location of all emergency stop switches, pull cords, and/or kick plates and
use them in an emergency to stop machine motion.
Safety Alert Messages—Cylinder and Processing Hazards
BNWRUS03.C03 0000234586 C.4 B.3 A.4 1/2/20, 2:19 PM Released
The following are instructions about hazards related to the cylinder and laundering process.
DANGER: Entangle and Sever Hazards — Contact with goods being processed can
cause the goods to wrap around your body or limbs and dismember you.
The goods are normally isolated by the locked cylinder door.
� Do not attempt to open the door or reach into the cylinder until the cyl-
inder is stopped.
General Information
To Next Page
Loading...
