© 2014 MIMAKI ENGINEERING CO.,LTD. 5.1 P.4
5.1 Adjustments When Using Sublimation Transfer Ink
R.1.0
1
2
3
4
5
6
7
Head Height Adjustment
Before performing this work, check the items below:
• The clamp lever is at the lower position.
• The head gap is 2mm (the head height lever is at the lower position).
Work procedures
1. Remove the front cover U.
2. Move the head over the platen.
3. Remove the carriage cover.
INSTALLATION GUIDE > Ink Set > Adjustments When Using Sublimation Transfer Ink
Model
CJV300
Issue
2014.09.01
Revised F/W ver.
1.30
Remark
1.0
To Next Page
Loading...
