MIMAKI CJV300-130 - Print Origin and Heater Settings

© 2014 MIMAKI ENGINEERING CO.,LTD. 7.1 P.4
7.1 Performing the Initial Ink Fill
R.1.0
1
2
3
4
5
6
7
 Working procedure 2 (Filling fluid discharging)
7. Remove the cartridge.
8. Press [ENTER], and discharge the filling fluid within the ink
route.
9. Press the [ENTER] key.
 Working procedure 3 (Filling fluid filling)
Discharge SHIPPING LIQID
Remove Cartridges
Discharge SHIPPING LIQID
Start
Discharge SHIPPING LIQID
Discharging
Please Waint…
 Be sure to confirm that no cartridge has been set.
 Only implement “Fill up FILLING LIQUID” when you selected “SOLVENT” for the ink type.
If you selected “AQUA”, proceed to step 14.
INSTALLATION GUIDE > Outputting Plots > Performing the Initial Ink Fill
Model
CJV300
Issue
2014.09.01
Revised F/W ver. 1.30 Remark
1.0
Rev.