MIMAKI JFX500-2131 - Chapter 1 Before Use

- 15 -
3.
Select the job created in step
2 from the job list.
• Click the “Properties” icon.
• Click the [Setup] button in the [Job
Attribute] field.
4.
Select the [UV Mode] tab.
• Make the settings as follows.
(1) Select “Glossy Print” in the
mode list on the left side.
(2) Additional UV irradiation: 1 time
Irradiation 1Illuminance: 100%
(3) Click the [OK] button.
5.
Job list of attribute becomes a "Clear
(Glossy)".
6.
Choose again the job selected in step 1.
• Click the [Special plate] icon.
7.
Make the settings as follows.
(1) [Special Color]：Ink = Clear
Clear= Select “40%”.
(2) Set [Composite automatically]: OFF.
(3) Click the [Create] button.
• Concentration of clear ink of base
clear is 40%.
(2)
(1)
(3)
(1)
(2)
(3)