MIMAKI JFX550-2513 - Cap Rubber Cleaning; Station Area Cleaning

3. Performing Maintenance
10
6
Reattach the wiper at the original position.
Lug
7
Tap [Complete] > [Finish] once cleaning is complete.
Cap Rubber Cleaning
The cap rubber keeps the print head nozzle surface from drying out. Continuing to use a dirty cap may affect
ink take-up and lead to print defects (e.g., nozzle clogging, deflection).
• Be careful to avoid leaving fragments from the cleaning stick behind when cleaning. These
fragments will increase the risk of printing defects (e.g., nozzle clogging or deflection).
1
From MENU on the touch panel, tap [MAINTENANCE].
• The Maintenance menu is displayed.
2
Tap [Daily maintenance] > [Daily station maintenance].
• The carriage moves over the table.
3
Clean the cap rubber.
• Wipe off any ink and dust adhering using a cleaning stick moistened with maintenance liquid. Wipe
off the maintenance liquid. Make sure none remains.
Cap rubber cover
Cap rubber
4
Tap [Complete] > [Finish] once cleaning is complete.
Station Area Cleaning
Continued use when dirty may prevent ink from flowing into the waste ink tank or cause dried ink and
attached dust to rub against the head nozzle surface, leading to print defects (e.g., nozzle clogging,
deflection).