MIMAKI JFX550-2513 - Usage Restrictions

3. Importing Jobs in MPC via Shared Folders
13
1
Specify a shared folder in [Select output folder] on the RasterLink status screen according to
the intended use.
• To print from the [JOB LIST] on the touch panel after outputting a job
-> Select SharedJob. (e.g. [\\*******\SharedJob])
• To start printing automatically after outputting a job
-> Select HotFolder. (e.g. [\\*******\HotFolder])
• Please change "********" to the serial number of the printer.
• From MENU on the touch panel, tap [SYSTEM] > [System information] to display the
serial number on the browser screen at right.
2
Select [Print and RIP] from RasterLink.
• If the output destination is set to SharedJob:
-> The RIP job is added to the job list.
• If the output destination is set to HotFolder:
-> "Receiving Job" is displayed in the lower-left corner of the MPC screen during job output.
3
Depending on the selected shared folder, the following actions are taken.