EasyManuals Logo

MIMAKI JV5 Series Maintenance Manual

MIMAKI JV5 Series
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #253 background imageLoading...
Page #253 background image
© 2009 MIMAKI ENGINEERING CO.,LTD.
7.1.1 P.2
7.1.1 Concerning Errors and Malfunctions
1
2
3
4
5
6
7
8
Checking procedure
This section describes troubleshooting procedures for the problems for which error messages are displayed.
1. Identifying the error category
The causes of errors can be classified into the following categories:
Handling error on the host computer side
Trouble on the host computer side
Trouble with the interface cable
Printer handling error
Printer mechanical trouble
Printer hardware trouble
Printer firmware trouble
2. Initial action
Refer to the error message, and judge whether the trouble lies on the host computer side or on the printer side.
Has any of the interface conditions (printer model setting, command, communication conditions, etc.) been
changed?
Does the trouble occur under specific conditions?
Does the same trouble occur repeatedly?
3. Failure on the printer side
Take the following steps to repair the printer.
Replace the defective part (sensor, etc.) or make the necessary adjustment.
Replace the main PCB assy.
4. Repair at the factory
If the error recurs even after the corrective measures specified here are taken, return the plotter to the factory of
MIMAKI for repair.
R.1.0
Maintenance Manual > Troubleshooting > Details on Errors and Malfunctions > Concerning Errors and Malfunctions
Model CJV30/TPC Issued 2008.08.04 Revised F/W ver. 1.00 Remark
1.0
Rev.

Other manuals for MIMAKI JV5 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the MIMAKI JV5 Series and is the answer not in the manual?

MIMAKI JV5 Series Specifications

General IconGeneral
BrandMIMAKI
ModelJV5 Series
CategoryPrinter
LanguageEnglish

Related product manuals