2
2. Daily care
(1) Surroundings of the heads ("Cleaning the Head and the Area around It" Chapter 4 of
the Operation Manual)
1
Move the carriage to the left and open the left
maintenance cover.
• Refer to the Step 1 to 5 of Chapter 4 “Cleaning the Head
and the Area around It” of the user’s manual to perform
the operation.
2
Clean the head and the surrounding
area.
• Gelled ink and dust could stick under the slider
and the surroundings of the head.
• Scrape them off with clean stick etc. In this case,
never rub the nozzle portion of the head.
3
Clean the bottom surface of the UV lamp.
• If there is any ink stuck on the rear side of the
bottom surface of the UV lamp, apply the
cleaning solution for maintenance to a clean stick
and wipe the ink away.
Wipe off so that cleaning solution for
maintenance will not remain.
• When possible, use the cleaning stick (SPC-0527) for cleaning around the head/ capping station/ wiper.
Using the other cotton bud may attach lint, then it may damage the machine.
• Be sure to perform maintenance for the ink cap and the wiper of capping station every day. If you leave it
dirty, dirt may adhere to the nozzle surface, or, dust and dry ink may be rubbed against the nozzle. It may
cause discharge defect.
• Clean the bottom of carriage every day so that it will not get dirt from inks or dusts. If you leave it dirty, dust
and dry ink may be rubbed against the nozzle at wiping operation when performing head cleaning.
• When you clean the carriage bottom surface, fully be careful not to rub the nozzle surface.
• The heads and their surroundings are the parts most liable to be tainted in this machine and if
tainted, it could cause adverse effects to the functions of the machine and the results of the printings.
Moreover, as the head itself uses very fine mechanisms, sufficient precautions are required for the
care and maintenances.
Screw
Left side
maintenance cover
Rotate it left.
The nozzle part (Never touch it.)
Clean the side surface of the head
(shown in deep gray) with a clean stick.
Clean with a clean stick
or a waste cloth.
To Next Page
Loading...
Need help?
General