5
(5) Media press (“Cleaning the Media Press” Chapter
4 of the Operation Manual)
When the media press is covered with lint, dust, etc., a media
cannot be fed normally during printing or dust sticks to the noz-
zles, which may result in abnormal printing.
Clean the media press regularly with a dry cloth or paper towel.
If there is ink on the media press, wipe it away with a clean stick
dipped in washing liquid for maintenance.
(6) Media sensor ("Cleaning the Media Sensor" Chapter 4 of the Operation Manual)
The media sensors are located on the platen in the backside (3 places) and the bottom surface of the head (1
place). When the sensor is covered with dust, etc., it may
cause false detection of media.
Using a cotton swab, remove the dust, etc. accumulated on the surface of the sensor.
(7) Waste ink tank ("Discarding waste ink" Chapter 4 of the Operation Manual)
Refer to the Chapter 4 “Discarding waste ink” of the user’s manual to perform the operation.
• Turn off the main power and unplug the power cable
before maintenance.
• Do not allow liquids to get inside the product.Ingress
of liquids into the product may lead to failure, electric
shock, or fire.
• When using washing liquid for maintenance, be sure
to wipe it away completely so that none remains on
the media press.
• Do not press against the sensor with the cotton swab. Doing so could damage the sensor.
Media sensor
Media width sensor
The backside of the machine The lower surface of the head
To Next Page
Loading...
