9
(2) Remove the ink tank.
• Take care not to tilt the ink tank greatly when
removing the tank. It may cause ink leakage from the
cap.
(3) Set a new ink tank, and mount the ink filter.
• Tighten the joints on the top of the ink filter.
3
Refer to the Chapter 1 “Fill ink in the ink tank and charging” of the user’s manual to
perform the operation, and refill with new ink.
• Do not tighten the joint too much. Otherwise, the filter might
be damaged. Be careful.
• Do not pour the ink remaining in the removed ink tank into
the new tank.
• Request that an industrial waste disposal company process
the disposal ink.
• When the tube and cover are in contact, there are times
when the amount of ink can not be accurately detected. So
as not to contact to the utmost as shown in the figure
below, please be careful for the direction of the joint.
To Next Page
Loading...
