© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.6 P.1
1
2
3
4
5
6
7
8
6.2.6 Valve Assy
Work procedures
1. Execute [#ADJUST] — [HEAD WASH] to discharge the ink.
(Refer to 4.2.11)
2. Remove the following covers.
• ICU Cover F
• ICU Cover R
3. Remove snap pin A and then the link.
4. Removes screws to take off the cartridge solenoid BKT A
together with the solenoid.
5. Remove the valve N-3 M6 assy and loosen the joint screws to
remove the tube.
6. Reverse the disassembly procedure for reassembly.
Be sure to wear protective glasses and working gloves during the operation.
Ink may get into your eyes depending on the working condition, or hand skin may get rough if you touch
the ink.
Ink Cartridge Solenoid Assy
Valve N-3 M6 Assy
Link
Snap pin A
Cartridge Solenoid BKT A
Screw
Valve N-3 M6 Assy
RS O-ring
Joint Screw
Tube
Take care not to contaminate the surroundings with
ink. Also, take care not to lose the RS O-ring.
R.1.0
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Valve Assy
Model
TS34-1800A
Issued
2011.10.17
Revised F/W ver
1.20
Remark
1.0
To Next Page
Loading...
