MIMAKI TS34-1800A - Page 175

© 2011 MIMAKI ENGINEERING CO.,LTD. 6.2.7 P.1
1
2
3
4
5
6
7
8
MAINTENANCE MANUAL > Disassembly and Reassembly > Ink-related Parts > Cutter Assy
Model TS34-1800A Issued 2011.10.17 Revised F/W ver 1.20 Remark
1.0
Rev.
6.2.7 Cutter Assy
 Outline
This section describes an overview of the work and procedures for replacing the cutter assy (cutter unit + LED pointer).
 Work procedures
1. Turn the main power at the right side of the machine ON, and
move the head unit on the platen using [MAINTENANCE] —
[ST.MAINTENANCE] — [CARRIAGE OUT].
2. Turn the main power OFF.
3. Remove the front cover (4 screws), Y cover F (4 screws), and
head cover (2 screws) (Refer to 6.1.1).
4. Loosen the screws (x3) and remove the cutter unit.
5. Remove the connector from the PCB and then remove the LED
pointer.
6. Install using the reverse of the disassembly procedure.
7. Refer to 4.3.1 for more information on installation position
adjustments.
LED pointer
Cutter Unit
Turn the main power OFF when turning the power OFF. It is very dangerous if sleep mode functions
mistakenly during the operation.
Power
ON
<LOCAL.1> [#01] FUNCTION
MAINTENANCE<ent>
[FUNC]
Execute
CARRIAGE OUT
ST.MAINTENANCE
CARRIAGE OUT <ent>
MAINTENANCE
ST.MAINTENANCE<ent>
Cutter Unit
R.1.0