2
For safe operation
Installation environment and Notes on cleaning
• Use this machine in clean (less dust) environment. The use of fan and ventilator might because of
dusty environment.
They brow dust up dust around the machine.
• As using UV curing ink, install this machine in a well-ventilated area.
• Working environmental temperature is 20 to 35°C (68 to 95°F). Avoid using at lower orhigher than this.
Notes on cleaning
Cleaning exterior surfaces
If exterior surfaces of the machine is dirty, dampen a soft cloth with water or a neutral detergent diluted
with water, squeeze it and wipe the surfaces.
• Never disassemble this machine. Disassembling this machine can result in electric shock
hazards or damage to this machine.
• Prevent moisture from entering this machine. Moisture inside the machine can result in
electric shock hazards or damage to this machine.
• Before starting maintenance work, be sure to turn off the main power switch and unplug the
power cable; otherwise, an unexpected accident may occur.
• Perform maintenance after the LED UV has been sufficiently cooled, or burn injury may
occur.
• Do not use benzine, thinner, or any chemical agent containing abrasives. Such materials
can deteriorate or deform the surface of the covers.
• Do not apply lubricating oil or the like to any part inside this machine. Such materials can
cause this machine mechanism to fail.
• In case water or alcohol mixed into the UV curing ink (UV ink), flocculation would be
occurred. Be sure not to adhere water or alcohol not only on the nozzle and also near the
head.
• This machine uses UV curing ink (UV ink). When in daily care, be sure to put on
the supplied goggles and gloves.
To Next Page
Loading...
Need help?
General