3. Consumable Item Replacement
24
LED Glass Replacement
Replace with new LED glass if the ink hardens and the existing LED glass becomes dirty.
1
On the LOCAL mode screen, select [MENU] > [Maintenance], then press the [ENTER] key.
• The Maintenance menu is displayed.
2
Select [Station] > [Carriage Out] > [Move To Maint. Space], then press the [ENTER] key.
• The carriage moves to the maintenance space.
3
Open the maintenance covers.
4
Remove the LED glass.
• Unclip the tabs and slide the LED glass in the direction of the arrow to remove.
• Be careful not to apply too much force when unclipping the tabs. Disregarding this precaution may
result in breakage of the tabs.
5
Mount new LED glass.
• Insert until it clicks into place. Confirm that the tabs are engaged.
6
Once replacement is complete, close the cover, then press the [ENTER] key.
To Next Page
Loading...
