Minarik AC200 SERIES User Manual

14
NOTE: If the computer does not respond to the request for the next file name within five
seconds, the display will read SERIAL TIMEOUT!, which could indicate that the computer is
busy or there is a problem in the serial link.
5. Once the desired file is found, press ENTER. The display will read DOWNLOADING as
the EMP Programmer downloads the selected data file from the computer into the buffer.
6. Press TRANSFER TO EPM to copy the data file to the target EPM (refer to NOTE 1 in
Section 5.2.1 on page 8).
7. Remove the target EPM from the EPM PORT. The EPM is now fully programmed and
ready to be installed in a drive.
8. To program another EPM using the same data file, simply install another target EPM in the
EPM PORT and repeat step 6.
NOTE: If this procedure is attempted without a target EPM installed in the EPM PORT, the
display will flash EPM MISSING!. Press the MENU key to reset the display.
5.2.3 FILE TO EPM
This function copies the data from a data file stored in the EPM Programmer to the User
Settings and OEM Defaults area of the target EPM. The EPM Programmer can typically store
up to thirty data files (depending on the configuration version), which are created using the
CREATE NEW FILE option on the Main Menu (refer to Section 5.2.5).

Minarik AC200 SERIES Specifications

General

Brand	Minarik
Model	AC200 SERIES
Category	Controller
Language	English