Minarik AC200 SERIES User Manual

5.2.1 MASTER TO EPM
This function copies the data from the User Settings area of the MASTER EPM to the User
Settings and OEM Defaults areas of the target EPM in the EPM PORT. The OEM Defaults (if
any) in the MASTER EPM are not copied to the target EPM. Therefore, in order to program
OEM Defaults into target EPMs, the parameter values in the User Settings area of the
MASTER EPM must be set to match the desired OEM values.
NOTE: Please refer to Section 2.0 in this manual, and the AC100 or AC200 Series Installation
and Operation Manual (Section 13.2 and Parameter 48 in Section 15.0) for more information
on the Electronic Programming Module (EPM).
Follow the procedure below to copy data from the MASTER EPM to the target EPM:
1. Install the EPM to be copied in the MASTER AND CONFIGURATION PORT.
2. Install the EPM that will receive the data into the EPM PORT.
3. Use the MENU key to scroll to MASTER TO EPM.
Press ENTER. The display will show the file name (if any) and the parameter version number
of the MASTER EPM. The example file below is named MINARK, and the parameter version
is 309.

Minarik AC200 SERIES Specifications

General

Brand	Minarik
Model	AC200 SERIES
Category	Controller
Language	English