25
2. Press ENTER. The display will flash SELECT DATA FILE, and then show a file. A
blinking cursor will appear on the right side of the display.
If the data file that appears is the desired one, go to Step 3.
Use the V and W keys to scroll through the data files.
5.2.6 DELETE DATA FILE
This function is used to delete data files that are stored in the EPM Programmer. The EPM
Programmer can typically store up to thirty data files. If the EPM Programmer’s memory is
full, and an attempt is made to create a new file, the EPM Programmer will display NOT
ENOUGH SPACE. In this case, old or obsolete files would need to be deleted to make space
for new files. Before deleting files, however, TechLink (requires version 1.12 or newer) can
be used to save them to disk.
NOTE: If an attempt is made to delete the DEFAULTS data file, the display will flash READ
ONLY FILE! The DEFAULTS data file cannot be edited or deleted.
Follow the procedure below to delete a data file stored in the EPM PROGRAMMER:
1. Use the MENU key to scroll to DELETE DATA FILE.
To Next Page
Loading...
Need help?
General
