1.0 GENERAL
1.1 PRODUCTS COVERED IN THIS MANUAL
This instruction manual covers the Minarik EPM Programmer which is used with the Minarik
AC100 and AC200 Series Variable Frequency Drive. The EPM Programmer can also interface
with Minarik’s TechLink serial communications software. Please refer to the instruction
manuals provided with the AC100 and AC200 drives and TechLink software for more
information.
1.2 PRODUCT CHANGES
Minarik Corporation reserves the right to discontinue or make modifications to the design of
its product without prior notice, and holds no obligation to make modifications to products sold
previously. Minarik Corporation also holds no liability for losses of any kind which may result
from this action.
1.3 WARRANTY
Minarik Corporation warrants the EPM Programmer to be free of defects in material and
workmanship for a period of twelve months from the date of sale. If an EPM Programmer,
which under normal use, becomes defective within the state warranty time period, contact
Minarik’s Service Department for instructions on obtaining a warranty replacement unit.
Minarik Corporation reserves the right to make the final determination as to the validity of a
warranty claim and sole obligation is to repair or replace only the components which have been
rendered defective due to faulty material or workmanship. No warranty claim will be accepted
for components which have been damaged due to mishandling, unauthorized repair and/or
alteration of the product, operation in excess of design specifications or other misuse, or
improper maintenance. Minarik Corporation makes no warranty that its products are
compatible with any other equipment (other than those stated herein), or any specific
application to which they may be applied, and shall not be held liable for any other
consequential damage or injury arising from the use of its products.
This warranty is in lieu of all other warranties, expressed or implied. No other person,
firm or corporation is authorized to assume, for Minarik Corporation, any other liability
in connection with the demonstration or sale of its products.
1.4 RECEIVING
Inspect all cartons for damage which may have occurred during shipping. Carefully unpack
equipment and inspect thoroughly for damage or shortage. Report any damage to carrier
and/or shortages to supplier. All major components and connections should be examined for
damage and tightness, with special attention given to PC boards, plugs, knobs and switches.
2
To Next Page
Loading...
Need help?
General
