Operator’s Manual E - 1
E iScanHelper
By providing the referential information, such as, the ultrasonic image, the anatomic graphic,
scanning pictures/other scanning tips or diagnosis comments, the system helps the doctors to
operate the scanning by iScanHelper. Furthermore, it is a good platform for the self-learning and
training of ultrasound scanning technique for doctors. The system also plays a role in the assistant
software system in fulfilling training and education.
THIS “iScanHelper” IS FOR REFERENCE OR TUTORIAL PURPOSES ONLY, AND THE
MANUFACTURER WILL NOT BE LIABLE FOR DAMAGES AND/OR OTHER
UNDESIRABLE CONSEQUENCE IN ANY KIND THAT MAY OCCUR TO THE PATIENT OR
THE USERS BY USING THE SOFTWARE.
iScanHelper feature is available under abdominal, gynecological, urological, obstetrical, small parts
and nerve block area.
E.1 Use iScanHelper for Reference
Perform the following procedure:
1. Perform ordinary scanning procedure.
2. Press the user-defined key for “iScanHelper” to enter iScanHelper status.
3. Use the trackball/trackpad to move the cursor onto the target view name in the view selecting
box and then press <Set>.
4. Perform scanning according to information displayed on the help information area.
5. Press the user-defined key again to exit.
E.2 Use iScanHelper for Learning or Training
Perform the following procedure:
1. Switch to the exam modes that support iScanHelper.
2. Press the user-defined key for “iScanHelper” to enter iScanHelper status.
3. Learn and practice views by system defaulted sequence according to the information displayed
on help information area; or select unfamiliar views to practice.
4. Press the user-defined key again to exit iScanHelper.
To Next Page
Loading...
Need help?
General
