Accutorr 7 Operator’s Manual 2 - 13
2.6.3 Standby Mode
In Standby mode, the patient is not being monitored, but the monitor is still powered
on.
If no parameter is being measured, you can press the power switch to enter Standby
mode. A warning pops up. Select [Ye s ] to enter the Standby mode.
When the monitor is powered by a battery, it will automatically enter the Standby mode
when the following conditions are satisfied:
â– No key operation within 10 minutes.
â– No unacknowledged alarms.
To exit Standby mode, use any one of the following methods:
â– Press any hardkey on the front panel.
â– Rotate the knob.
â– Connect SpO
2
sensor, and let the monitor receive SpO
2
signal for more than 5
seconds.
â– Remove the temperature probe from the probe well.
• If the monitor enters and then exits Standby mode during patient
monitoring, you must re-admit the patient before continuing monitoring.
• The device will not allow the user to enter Standby mode when the battery
power is low.
2.6.4 Demo Mode
Demo mode is password protected, and it is used for demonstration purpose only.
To enter Demo mode:
1. Select [Main] → [Maintenance>>].
2. Select [Demo>>] → enter required password → Select [Ok].
To exit Demo mode:
1. Select [Main] → [Maintenance>>].
2. Select [Exit Demo].
• The Demo mode is for demonstration purpose only. To avoid the potential
risk of the simulated data being mistaken for the monitored patient’s data,
To Next Page
Loading...
Need help?
General
