Minelab F3

F3 Service Manual
Page 22
Disassembly & Reassembly Procedures
3.4 Introduction
This section describes the procedures required to exchange line replaceable units.
Whenever a unit is replaced, mechanical and functional testing as described in section
3 Mechanical and Function Testing must be completed.
3.5 F3 Tool Kit
The F3 Tool Kit (Part No 3004-0018) is required to disassemble and reassemble the
F3. The tool kit (Figure 10) comprises:
Table 5: Tools
Minelab Part No Description
71-0005-0006 Silicon Grease (100g tube)
71-0005-0010 Silicon Sealant (75g tube)
75-8701-0009 Tubular Spanner 7/8”
8701-0010 F3 Coil Cable Pull Through
75-8701-0011 Screwdriver Pozidrive No 1
75-31400-010 Hex Driver 2.5mm
75-31400-011 Hex Driver 3.0mm
75-8701-0013 Flat blade screwdriver 6.5mm x 150m
4904-0004 Service Manual F3
Figure 10: Tool Kit.
NOTE
All tools except the F3 Coil Cable Pull Through are commonly available. If
necessary, a length of string can be used as the F3 Coil Cable Pull Through.