F3 Service Manual
Page 31
3.7 Coil.
Figure 23 illustrates the major parts involved in removing and replacing the coil.
Figure 23: Coil.
Table 2: Coil
3004-0003 Coil Kit F3, includes all items in this table
3004-0038 Coil Retainer Kit, Contains Pt 1 & 3
1 2004-0037 Retainer Coil
3 4005-0039 Block Friction Coil
2 2021-0054 Coil F3
4 8009-0007 Retainer Plug
5 4308-0012 Pin Coil Cable
2003-0043 Skid Plate
a. To Replace the Skid Plate:
All Minelab coils should have a skid plate attached to the underside of the coil,
the skid plate is designed to protect the coil from wear and tear caused by
contact with the ground. The skid plate may need replacing particularly after
prolonged heavy use. There is no requirement to remove the skid plate to clean
inside during routine maintenance.
To remove the skid plate use fingers to lever it from the coil. To attach a skid
plate to the coil it must be pressed onto the bottom of the coil.
To Next Page
Loading...
Need help?
General
