Minelab F3

F3 Service Manual
Page 59
Figure 60: Shafts
3.13 Shafts.
The following procedures detail shaft disassembly/assembly and should be followed
in order until the component to be replaced is accessible. Figure 60 illustrates the
components of the shaft assembly.
a. To Disassemble Camlock Lower and Lower Shaft:
Figure 61: Camlock Lower.
Table 8: Camlock Kit Lower
3004-0011 Camlock Kit Lower, contains items 1 to 5
1 8007-0022 Camlock Body Lower
2 8008-0071 Pressure Block Lower (include wear plate)
3 8008-0030 Wear Plate
4 8008-0029 Cam Lever Lower
5 4308-0008 Pin Lower Camlock
8007-0028 Lower Shaft (not part of camlock kit lower)
Upper Shaft
Camlock Upper
Lower Shaft
Camlock Middle
Camlock Lower
Middle Shaft
Lower Shaft
Upper Shaft
Camlock Middle
Camlock Kit
Lower