Minelab GPX-4500 User Manual

46
47
The GPX-4500 is provided with a Factory
Preset selection of menu settings, suitable
for first-time users.
Until you become more familiar with the
GPX-4500 the detector can simply be
operated with the Factory Presets and the
front panel controls.
To restore all Factory Preset settings:
1 Turn the detector off.
2 Press and hold the On/ Off switch until the Reset
Defaults menu appears (approx. 5–6 seconds).
3 Turn Function Select to the right to select All
Settings (as shown on the diagram).
4 Turn Setting left or right to restore all
Factory Presets.
Note: When performing an All Settings reset, the
settings for the four Custom Search Modes are
preserved. This is to prevent your own favourite
mode settings from accidentally being erased
whilst allowing the LCD menu, Deep Mode and
General Mode settings to be quickly restored to
factory settings.
Function
Select
Setting
On/Off
Hold for FP
On/Off
Hold for FP
Resetting Factory Presets
Function
Select
Setting
On/Off
Hold for FP
To restore Factory Preset settings for the
current search mode:
Note: If you wish to reset a Custom Search Mode
ensure it is selected in the menu before shutting
down the detector.
1 Turn the detector off.
2 Press and hold the On/ Off switch until the Reset
Defaults menu appears (approx. 5–6 seconds).
3 Turn Function Select to the right to select the
current mode.
Note: If the displayed Search Mode is not the one you
wish to restore you must change the Search Mode on
the front panel switch or select the correct Custom
Search Mode from the LCD menu.
4 Turn Setting left or right to restore Factory
Preset settings for that mode.

Minelab GPX-4500 Specifications

General

Search Modes	General, Deep, Custom
Battery Life	Up to 12 hours
Ground Balance	Automatic and Manual
Display	LCD
Technology	MPS, DVT, SETA
Coil	11" Double-D Coil
Audio Output	Internal speaker, headphone jack
Battery	Lithium-ion
Waterproof	Coil is waterproof
Warranty	3 years