Custom Name
When creating your own custom mode, in one of
the four Custom Search Mode options, you can
personalise the mode by selecting a name from
the list.
For example, if you regularly detect in exposed
bedrock you can set your own Custom 'Bedrock'
Search Mode:
1. Select Custom on the Search Mode switch (located
on the front panel).
2. Scroll down the menu and a Search Mode will be
highlighted, e.g. Patch.
Custom Names
Patch
Bedrock
Pinpoint
Gridding
Diggings
Salt Lake
Hi-Mineral
Lo-Mineral
Very Deep
Shallow
Hi Trash
Beach
Test A
Test B
1.
3.
4.
3. Scroll to the bottom of the menu until you see
Custom Name.
4. Using the Setting knob scroll down until 'Bedrock'
is selected, then move the function knob to apply
the name change.
5. The Search Mode name is now Bedrock and any
mode specific setting changes you make are
automatically saved when you switch the unit off.
6. You can now switch between Deep, General and
Custom/Bedrock via the Search Mode switch on
the front panel.
Note: Even when doing an All Settings Factory Reset
your Bedrock, or other Custom Modes, settings are
still preserved.
To Next Page
Loading...
Need help?
General
